Spring...when flowers bloom, gardens get planted, and birds sometimes decide to use the 4-inch rain gauge for a perch and/or a porta-potty. Although a properly perched bird or two can be a great photographic opportunity, more often than not they leave a mess. What can you do to discourage our feathered friends from perching on the gauge while at the same time not affecting the catch of the rain gauge? A few years ago Nolan Doesken, CoCoRaHS founder, put out an appeal for suggestions on how to deal with this problem. He received quite a range of ideas. Here are a few of them.
- Use tape to attach tooth picks or thin, rigid wires to the rim of the gauge about every1 ½ to 2 inches and sticking up about 2" above the rim.
- Mount a ring of stakes with flags or streamers or shiny stuff around your gauge making sure they stick up a bit higher than the gauge. You can now even purchase holographic ribbon tape that is claimed to scare away birds.
- Real cats
- Stuffed cats
- Rubber snakes
- Real snakes
- Plastic owls
- Electronic owls
- WD-40 or similar smelly solvent/lubricant applied to the outside of the funnel. A problem with this is that it will likely have to reapplied often, and it could be messy.
I tried one trick suggested by an observer in our CoCoRaHS Facebook group last year. They suggested putting something in the vicinity of the gauge higher than the top of the funnel. Birds often perch on the funnel because it's the highest vantage point in the area. If you give them something that is higher than the gauge, they will tend to use that instead. This could be a shepherd's hook plant hanger or something similar. I attached pieces of scrap wood to my post in an "L" configuration. This seemed to work well as I only had one to two instances of "improper use of the funnel".
If you search "birds" in our Facebook group you will find photos of some rather ingenious wire configurations to deter birds. Here is one of my favorites (which no doubt took a lot of work) by Richard Martin. If I were a bird I'd think twice about getting close to this one!
Two things to keep in mind if you are creating your own deterrent. Nothing should be in the funnel, and any wires, etc. should be bent slightly away from the funnel so that water doesn't collect on them and drip into the gauge.
The toothpick/wire idea is probably the easiest. Here are some instructions on making the toothpick deterrent.
- Cut about a 14 inch long piece of ¾ duct tape. Lay it adhesive side up on a flat surface, and fasten down each end with a small piece of tape.
- Arrange toothpick on the tape about one to one and a half inches apart. Round toothpicks are best – the have a little more heft to them. Press the toothpicks on to the tape so they adhere.
- When you have arranged all the toothpicks, cut the strip free on both ends, inside of where you taped it down.
- Wrap the tape with the toothpicks around the edge of the funnel, keeping the top edge of the tape at or just below the edge of the funnel. Overlap the ends, and then press firmly all around the funnel.
For the photos below I used masking tape, but that will not hold up very long in wet weather. Duct tape or some other moisture resistant tape is best. Since you won’t find duct tape in a ¾” width, you will need to rip a strip approximately that wide from a wider strip. This is easy to do – first snip the end of the wide piece of tape with a scissors, and then rip the narrower piece off.
Good luck with the birds this season.
I hot glued galvanized finishing nails around the outside edge of the funnel. Like the toothpicks shown. Has worked wonders, no unauthorized use of the gauge since. Going on three years now.
ReplyDeleteI now have squirrels taking off the funnel cap, and messing with the gauge,,I will try to tape the gauge on and see
ReplyDelete